General

Personal Protective Equipment (PPE) required

All work places differ with regards to the use of PPE. Please wear the appropriate PPE required by your locations working regulations.

(e.g. boiler suit, safety gloves, hard hat, hearing protection, safety glasses, high visibility work vest)

Drilling Scotgrip® anti-slip material

Most Scotgrip® anti-slip safety products are delivered pre-drilled for speed of installation. If you need to drill holes in our products then please use the following guidelines.
  1. Place the anti-slip material with the rough side down.
  2. Mark out holes to be drilled.
  3. Drill through the anti-slip material with an appropriate masonry drill bit.
  4. When using M8 bolts it is advisable to countersink the hole on the anti-slip surface with a 16mm ∅ (5/8" ∅) masonry drill bit. This allows for correct seating of the bolt.
Fixing type Drill bit
M8 bolt 9mmØ (3/8" Ø)
Concrete hammer screw 6mmØ (1/4" Ø)
Self tapping/woodscrew 5mmØ (3/16" Ø)

Cutting Scotgrip® anti-slip material
  1. Place the anti-slip material with the rough side down.
  2. Mark out the area to be cut.
  3. Cut the material with a cutting disc. lf unable to use a cutting disc or there is no power available then a hacksaw can be used to cut the material.
Cleaning Scotgrip® anti-slip material

Scotgrip® anti-slip safety products are easily cleaned. The frequency of cleaning will differ from location to location depending on the debris / dirt / grime levels in each working environment. The following methods are advised:
  1. Sweeping with a stiff bristle brush.
  2. Applying 'rigwash' type de-greaser then sweeping with a stiff bristle brush.
  3. Jet-washing the surface is the preferred method where possible.
For Further advice / information to prevent 'Slips & Trips' in your workplace please contact us